INTRODUCTION CONTACT US TECHNOLOGY PERSONNEL HISTORY WWW.BEK.COM LASER SCANNING  |  DELIVERABLES ACCURACY TURNAROUND 3D CAD FORMAT COST-EFFECTIVE QUALITY CONTROL FIELD TIME LASER Our Clients BE&K As-Built Services supplies a wide range of support services to engineers, contractors, and owners. Feel free to look at we have done for some of our clients: Carter, Holt, Harvey Gaylord Container Corporation International Paper Inter-Uhde Lockwood Green Packaging Corporation of America Pfizer Pharmesicutals Rayonier Sonoco Products Southern Company Services Shering Laboratories Tennessee Valley Authority Uhde-Engenharia Ltda Union Camp Corporation Confidential Client : Packaging Corporation of America Project : No. 2 Paper Machine Retrofit Location : Counce, Tennessee Volume : 324,000 cu ft Duration : 3 Months Project Description In preparation for a major machine and process upgrade by BE&K Engineering, a precise 3D model of the existing Counce mill was created to to ensure that all undocumented modifications were accounted for, and that space tolerances, both before and after demolition, could be determined accurately. Scope of Services A site visit was made to gather control data, and to capture the required information. An intelligent PDMS CAD model was then generated of the 35 bays spread over the basement, operating, and mezzanine levels of the drive aisle, including the design of cantilevered beams throughout all levels. The model was accurate to ± 1/4 in. and included all piping, equipment, structures, and ductwork. Two-dimensional CAD drawings were also produced from the model to support the engineering effort. Client : Packaging Corporation of America Project : Refiner Exchange Location : Counce, Tennessee Project Description PCA planned to improve the refining process at the Counce mill by removing and replacing a refiner in the stock preparation area on the operating floor. A 3D as-built model was considered the quickest and most cost-effective method to guide this delicate procedure in a densely piped area.BE&K Engineering used the new model adjacent to our previous PCA/BE&K model, to accurately design and install the latest configuration. Scope of Services Control data and as-built information were gathered during a trip to the mill. An intelligent 3D CAD model of all equipment, structural steel, and ductwork was produced to represent the 17-bay area. The model also included piping rework for the existing and new refiners. The model was accurate to ± ¼ in. and was delivered in PDMS format.